Skip to content
EpiTechElectronics for MBE
  • Power & temperature

    • Effusion cell power supplies
    • Substrate heater power supplies
    • Heated viewport power supply
    • Eurotherm boxes
    • Multizone bake controllers

    Motion

    • Motion control family
    • Valve positioners
    • CAR rotation & position
    • Sample elevator controllers

    System control

    • Modular system controller
    • Shutter controllers

    Sources & pumps

    • Gas manifold controllers
    • White phosphorus controller New
    • Titanium sublimation pumps (TSP)
    All products →The complete package →epiware llc ↗
  • Complete Package
  • EpiLink
    • Service + Maintenance
    • MBE Modernization
    • MBEs for Sale
    • Schedule an Assessment
    • About EpiTech
    • Leadership
    • Customers
    • EpiLog (news)
  • Contact

EpiLink

EpiLink lets compatible EpiTech controllers tell MachineStudio what they are and what they can do. The device carries its own description in firmware, so MachineStudio can build the driver from the hardware itself.

From Ethernet address to instrument

Highlight a step
  1. Two EpiTech SmartMotion controllers for CAR rotation and positioning

    Enter the Ethernet address

    Open Add EpiLink Device and enter the controller’s IP address. Change the port or Modbus unit ID if your setup calls for it.

  2. Device identityMeasurements and unitsAvailable commands

    Read what the device reports

    MachineStudio reads the description stored in the firmware and shows the parameters and capabilities it can configure.

  3. Machine configuration↳ Instrument↳ Generated driver

    Review and add the instrument

    Name the instrument, choose where it belongs in the machine tree, and select Add. MachineStudio creates or updates the driver for you.

Compatible hardware

EpiLink is available in firmware for the SmartMotion CAR controller and SmartValve. Ask us to confirm support for your specific model and firmware edition when ordering or upgrading.

EpiLink is part of EpiTech’s direction for new smart hardware. The MachineStudio setup shown above uses Modbus TCP over Ethernet.

Ask about your hardware See EpiLink in MachineStudio
EpiTech

Electronics and control systems for molecular beam epitaxy.

610 Nicoll Ave, Baltimore, MD 21212
443-295-3625
[email protected]

Products

  • All products
  • Power supplies
  • Motion control
  • System controllers
  • White phosphorus
  • Ti sublimation
  • The complete package

Services

  • Service + Maintenance
  • MBE Modernization
  • MBEs for Sale
  • Schedule an Assessment

Company

  • About EpiTech
  • Leadership
  • Customers
  • EpiLog (news)
  • Contact
  • LinkedIn
  • Facebook

© 2026 EpiTech, LLC. All rights reserved. EpiTech™ and SmartPower™ are trademarks of EpiTech LLC. Molly, ECS, AMBER, Nova, Crystal XE, and other third-party product names and trademarks belong to their respective owners. Crystal XE is a product of RIBER. These names are used for identification and to describe compatibility; no affiliation or endorsement is implied. MachineStudio is supplied separately by epiware llc.